34
DW-71-H
PACKING
1. Fix the front door of water tank to the main body
(left and right sides) with tape.
2. Engage the power cord with the cord catch
(upper), and fix it with tape.
5. Put in the bottom pad, put the product, and put
on the top pad.
3.1 Put the top protecting sheet before inserting the
product into a plastic bag.
3.2 Insert the product into a plastic bag, and fix its
opening with tape.
4. Fix the bottom flaps with staples.
Tape 40mm x 40mm
Tow places at both sides
(fold back the tape).
Tape 25mm x 150mm
(fold back the tape).
Front door
Water tank
Tape 25mm x 150mm
(fold back the tape).
Power cord catch
Power cord
Fix the bottom flaps with staples.
Fix flaps with 4 staples.
Case
6. Insert the edges of outer top flaps of case into the
slits of inner flaps to close the top.
Plug
Plug protector
Printed matters)
Put the side of the polyethylene bag to the
left of the product, and put the ten pad on them.
Tape 18mm x 60mm(Yellow)
Printed matters
Top pad
Case
Plastic bag
Adhesive tape 18mm x 150mm
To Next Page
Loading...
