To Next PageTo Next PageHow to align copies from the exposure glass on my Sharp DX-C200?
When copying from the exposure glass on your Sharp Printer, place the original copy side down, making sure that it is aligned to the rear left corner and pressed flat against the exposure glass.
How to adjust the scan image that is too dark or too light on Sharp DX-C200?
If the scanned image from your Sharp Printer is too dark or too light, you should adjust the image density.
How do I lighten or darken copies on my Sharp Printer?
If the copied pages from your Sharp Printer are too dark or too light, you can adjust the image density.
Why is the photocopied paper from my Sharp Printer dirty?
If the photocopied paper from your Sharp Printer is dirty, consider the following: * Adjust the image density, as it may be too high. * Avoid touching printed surfaces immediately after copying, and remove freshly printed sheets one by one. * Ensure the exposure glass or ADF is clean. * Before placing originals on the exposure glass, make sure that toner or correction fluid is dry.
Why won't my Sharp DX-C200 Printer start scanning?
If your Sharp Printer does not start scanning, check if the ADF or ADF cover is open. If it is, close it completely.
How to collate photocopied pages on my Sharp DX-C200?
To collate photocopied pages on your Sharp Printer, change the [Sort] setting under copy settings on the control panel.
Why is the toner powdery on prints from my Sharp DX-C200 Printer?
If the toner is powdery and comes away from the paper, or the printed image has a matte appearance on your Sharp Printer, check if the fusing unit levers are properly set. Pull up the fusing unit levers.
How to prevent printed envelopes from creasing on my Sharp Printer?
To prevent printed envelopes from coming out creased on your Sharp Printer, check if the fusing unit levers are properly set. Lower the fusing unit levers.
Why are images printing diagonally on my Sharp DX-C200 Printer?
If images are printing diagonally on the pages from your Sharp Printer, adjust the paper guides to remove any gaps between the paper and the guides.
Why does the paper get wrinkles when printing with my Sharp Printer?
If paper gets wrinkles when printing with your Sharp Printer: * Use paper that has been stored properly, as damp paper can cause wrinkles. * Ensure the paper isn't too thin. * Adjust the paper guides to remove any gaps between the paper and the guides.
General| Functions | Print, Copy, Scan |
|---|---|
| Print Technology | Laser |
| Print Speed | 20 ppm |
| Print Resolution | 600 x 600 dpi |
| Scan Resolution | 600 x 600 dpi |
| Copy Speed | 20 cpm |
| Paper Capacity | 250 sheets |
| Connectivity | USB 2.0 |
| Scanner Type | Flatbed |
| Paper Size | A4 |
