ER-A410/ER-A420 PROGRAM (PGM2/PGM1) MODE
2 – 9
If the record of entered PLU code is not in PLU file at this programming,
it will be created in PLU file.
MRS = 00000
[JOB#2214]
PLU TEXT PROGRAMMING
Characters can be entered by using character keys or numeric keys.
The key entry sequence for entering one character by numeric keys is
as follows:
If the record of entered PLU code is not in PLU file at this programming,
it will be created in PLU file.
MRS = PLXXXXXX
[JOB#2219]
PLU CODE DEFINITION FOR DIRECT PLU KEYS
MRS = STANDARD KEY LAYOUT
[JOB#2220]
LINKED PLU PROGRAMMING
When the “ST” key is pressed without entering any number as the first
PLU code (YYYYYY), the previous data is cleared.
PLU code should already be defined when they are used in program-
ming here.
MRS = 0
[JOB#2221]
SET PLU (COMBO) programming
When the “ST” key is pressed without entering any number as the first
PLU code (YYYYYY), the previous data is cleared.
PLU code should already be defined when they are used in program-
ming here.
MRS = 0
[JOB#2230]
PLU CODE PROGRAMMING (range)
It changes the data of PLU records only which exists in PLU file in the
entered range of PLU code.
D: Taxable 2 D
Non taxable 0
Taxable 1
E: Taxable 1 E
Non taxable 0
Taxable 1
XXXXXX: PLU code (1 to 999999)
Characters: MAX. 16Characters
XXX 3 00 KEY XXX: CHARACTER CODE (3 DIGITS)
*First time = LEVEL1
The others = Same as previous level
XX: Key No. (Assigned by SRV#951)
YYYYYY: PLU No. (1-999999)
2214 XXXXXX Character key
For next code
No change
ST TL
PLU code
No.
XXXXXX: PLU code = 1~999999 max.
YYYYYY: PLU code = 1~999999 max.
XXXXXX: Parent PLU code (1 to 999999 max.)
YYYYYY: Tied PLU code (1 to 999999 max.)
XXXXXX: Start PLU code = 1~999999
YYYYYY: End PLU code = 1~999999
ZZ: Dept. code = 1~Max number of DEPT.
2220 YYYYYYXXXXXX
Max. 5 times
Delete or skip
PLU code
TLST
2221 YYYYYYXXXXXX
Max. 5 time
s
TLST
Delete or skip
2230 YYYYYYXXXXXX
PLU code
ZZ
PLU code
TLST
Change to the data
of start PLU
To Next Page
Loading...
