Sharp ER-A410 - Page 47

ER-A410/ER-A420 OP X/Z, X1/Z1,X2/Z2 MODE
3 – 1
CHAPTER 3. OP X/Z, X1/Z1,X2/Z2 MODE
Roughly speaking, the following sales reports are available:
1) OP X/Z reports (individual clerk reports)
2) X1/Z1 reports (Daily sales total X and Z reports)
3) X2/Z2 reports (Periodic total X and Z reports)
4) Flash-read reports (Display sales amount)
In addition to the above the reports that are to be used for program
checking are also available.
[Purpose]
The above reports are each used to check sales data. The standard
purpose of taking these reports are as follows:
OP X/Z reports:These reports are taken by operators in order to report
their own sales data.
X1/Z1 reports: These reports are taken by the supervisor or manager
in order to check and report daily sales totals at that
point.
X2/Z2 reports: These reports are taken by the supervisor or manager in
order to check and report periodic (weekly or monthly)
totals.
Flash-read: These reports are taken by the owner or manager in
order to check and display sales totals at that point.
[Operation]
In the table below those reports marked with a circle “o” can be executed.
PRINTING REPORT
JOB# : ‘x’ is 1 for X1/Z1 mode, 2 for X2/Z2 mode, and 0 or nothing for OPX/Z mode.
JOB# Range is required
TL
Reading
Resetting
REPORT NAME JOB#
MODE *1
DATA FOR READINGOPX/Z X1/Z1 X2/Z2
X Z X1 Z1 X2 Z2
GENERAL x00 oooo *1
DEPT (ALL GROUP) x10 oo *1
DEPT (INDIVIDUAL GROUP) x12 ooGROUP No. *2
GROUP TOTAL x13 oo *1
PLU x20 ooooPLU CODE *3
PLU (DEPT) x21 ooooDEPT CODE *2
PLU STOCK x24 o PLU CODE *3
PLU ZERO SALES x27 oo *1
PLU PRICE CATEGORY x29 ooPRICE *3
TRANSACTION x30 oo *1
TL-ID x31 oo *1
COMMISSION x32 oo *1
CLERK (ALL) x40 oooo *1
CLERK (INDIVIDUAL) x41 oo *1, *5
CLERK (INDIVIDUAL) x41 ooooCLERK CODE *6
CASHIER (ALL) x50 oooo *1, *7
CASHIER (INDIVIDUAL) x51 oo *1, *5, *7
CASHIER (INDIVIDUAL) x51 ooooCASHIER CODE *6, *7
HOURLY (ALL) x60 oo *1
HOURLY (RANGE) x60 o TIME *3
DAILY NET x70 oo *1
PBLU x80 oo PBLU CODE *3
PBLU (CASHIER) x81 oo CASHIER CODE *1
BALANCE x82 oo *1
STACK REPORT x90 oooo *8