Sharp ER-A450T - Keys and Switches; Mode Switch and Mode Keys

Sending to the ER-A450T
Page / 11
Designs and specifications are subject to change without notice.
1. Connect the ER-A450T to the PC using the previously specified RS-232 cable.
2. From the Main Form using the drop down menu, select one of the following functions to be
performed;
(1) Send Logo1 when the image data is for the header
(2) Send Logo2 when the image data is for the footer
3. Click [ OK ] (Fig. 13)
4. The LOGOCONV.exe will prompt you if you have an image file ready for transfer to the ER-A450T.
Click [Continue] if you have a file that has been prepared. (Fig. 14)
5. Navigate to the applicable folder where the image data is stored and select the image. (Fig. 15)
PC
RS232 cable
Channel No.
Port1(CH8)
Channel No.
Port2(CH1)
(FIG.12)
FROM PC TO ER-A450
(FIG.13)
(FIG.14)
(FIG.15)