CHAPTER 3. OP X/Z, X1/Z1,X2/Z2
MODE
The following categories of reports can be printed by the ECR.
1) OP X/Z reports (individual clerk reports)
2) X1/Z1 reports (Daily sales total X and Z reports)
3) X2/Z2 reports (Periodic total X and Z reports)
To print reports, use the following key entry sequence
JOB# Range is required
Reading
Resetting
TL
MODE 1
OP X/Z X1/Z1 X2/Z2 F-read
3 DATA FOR
REPORT NAME X Z X1 Z1 X2 Z2 X1
4 JOB# READING NOTE
GENERAL
00 —
DEPT/GROUP
10 —
IND. GROUP
12 GROUP No.
GROUP TOTAL
13 —
PLU BY RANGE
20 PLU CODE 2
PLU BY DEPT
21 DPT CODE
PLU ZERO SALES
27 ALL
PLU PRICE CATEGORY
29 PRICE 2
TRANSACTION
30 —
TL-ID
31 —
COMMISSION SALES
32 —
ALL CLERK
40 —
IND. CLERK
41 —
ALL CASHIER
50 —
IND. CASHIER
51 —
HOURLY (ALL)
60 —
HOURLY (RANGE)
60 TIME 2
DAILY NET
70 —
STACKED REPORT
90 —
1 X1: Daily X report Z1: Daily Z report
X2: Periodic X report Z2: Periodic Z report
Stop of printing reports:
The printing of all reports can be stopped by the following operation.
Set the mode switch to "MGR" to cancel.
Note) When the printing is stopped, the consecutive number or Z
counter don’t return to the original value.
When Z reports, Memory is not reset.
1 X1: Daily X report
X2: Periodic X report
Z1: Daily Z report
Z2: Periodic Z report
2 PLU code range can be specified by entering the start and end
numbers according to the following procedure. When specifying
a single time interval, PLU code, the start number has only to be
entered.
3 When 2 is entered in the third digit of a job code, periodic reports
are printed.
Example: Daily general report; job code 100
Periodic general report; job code 200
4 Reading display only
→ KEY → CL
(Display amount) (Display initialize)
KEY DEPT = DEPTn key
CID =
⊗ key
Daily Net = ST key
• An individual report is printed on the receipt and journal when the
TL key is pressed.
• Pressing the decimal point key just after the entry of a job code
clears the corresponding data in the ECR. (Z report)
(When printing those reports for which no Z reports can be taken,
the decimal point key cannot be pressed after the entry of a job
code.)
• When the decimal point key is not pressed after the entry of a job
code, the corresponding data is held in the ECR. (X report)
XXXXXX XXXXXX
All
Start No. End No.
3 – 1
To Next Page
Loading...
