Sharp ER-A470

CHAPTER 4. CHANGING EURO
FUNCTION (X2/Z2 mode JOB)
This job is own to be able to be changed easily from local currency
system to EURO currency system in X2/Z2 mode.
(Changing EURO Function)
X: 1 = EURO STATUS (B)
2 = EURO STATUS (C)
[ About EURO STATUS ]
It is executing automatically to change from status (A) to status (B) or
(C).
Selectable type is one of below 3 types.
And the selectable type is decided as below for each status.
CURRENT STATUS
↓
Selectable STATUS
(A) (B) (C)
(A) — X X
(B) — — X
(C) — — —
Marked "X" is selectable
<Selecting type and its action>
(A) to (B):
1) Issue General Z1 report.
2) Issue General Z2 report.
3) Clear GT1/2/3.
4) Set PGM function "EX1 AMOUNT PRINTING FOR TOTAL
AND CHANGE" as "YES".
5) Set "Domestic currency symbol" as EURO SYMBOL.
(A) to (C):
1) Issue General Z1 report.
2) Issue General Z2 report.
3) Clear GT1/2/3.
4) Set PGM function "EX1 AMOUNT PRINTING FOR TOTAL
AND CHANGE" as "NO".
5) Set "Domestic currency symbol" as EURO SYMBOL.
(B) to (C):
1) Issue General Z1 report.
2) Issue General Z2 report.
3) Set PGM function "EX1 AMOUNT PRINTING FOR TOTAL
AND CHANGE" as "NO".
(Caution!!)
This JOB cannot set EXCHANGE1 RATE and EXCHANGE1 CUR-
RENCY SYMBOL automatically.
EX1 RATE and EX1 CURRENCY SYMBOL must be set by PGM
mode JOB after this job.
800
TL
X
Current domestic currency (i.e. DM)
Parallel usage of actual domestic currency (EURO) and previous domestic currency
(i.e. DM)
Current domestic currency (i.e. DM)
Actual domestic currency (EURO) only
Actual domestic currency (EURO) only
Parallel usage of actual domestic currency (EURO) and previous domestic currency
(i.e. DM)
4 – 1