If your Sharp Washer won't start, several factors could be the cause. First, ensure the machine is properly plugged into a working power outlet. Check the fuses and replace them if they are faulty. Also, verify that there is mains power supply. Make sure you have pressed the Start/Pause button and that the program dial is not in the 'stop' position, turn the programme dial to the desired position. Finally, ensure that the machine door is completely closed.
R
randy81Aug 20, 2025
How to fix Sharp ES-NFB814CWA-DE that does not discharge water?
A
Alicia GreenAug 20, 2025
If your Sharp Washer isn't discharging water, check the drain hose for clogs or twists; clean or untwist it as needed. Also, the pump filter might be clogged, so clean the pump filter. Ensure that the laundry is spread evenly in the machine.
D
Diane LopezAug 22, 2025
What to do if Sharp ES-NFB814CWA-DE does not intake water?
J
Joanna BarronAug 23, 2025
If your Sharp Washer isn't taking in water, start by checking if the water tap is turned on. Inspect the water inlet hose for any twists and untwist it if necessary. Also, the water inlet hose or inlet filter may be clogged, so clean the water inlet hose filters and the inlet filters. Lastly, ensure that the machine door is completely closed.
D
Donald PattonAug 26, 2025
Why is my Sharp ES-NFB814CWA-DE vibrating so much?
J
John StephensonAug 26, 2025
If your Sharp Washer is vibrating, make sure the feet have been adjusted properly. Check that the transit bolts, which are fitted for transportation, have been removed from the machine. If you have a small load in the drum, this will not prevent operation of your machine. Avoid overloading the drum and spread laundry evenly. Also, do not set up your Washing Machine on a hard surface.
C
Christy ReevesAug 28, 2025
Why spin cycle of Sharp ES-NFB814CWA-DE Washer is delayed?
C
Cody GlassAug 28, 2025
If the spin cycle in your Sharp Washer isn't happening or is delayed, it might be because the Unbalanced load control system has been activated. This system will try to spread your laundry, and the spinning cycle will begin once your laundry is spread. For the next wash, load the drum evenly.
J
Jessica LaneAug 31, 2025
How to improve washing result in Sharp ES-NFB814CWA-DE with hard water?
M
Michael ChristianAug 31, 2025
If you're getting unsatisfactory washing results with your Sharp Washer, and you have hard water, increase the amount of detergent following the manufacturer’s instructions. Also, check that your laundry is spread out.
K
Kathy HarrisSep 2, 2025
How to reduce foam in Sharp ES-NFB814CWA-DE Washer detergent drawer?
J
James RochaSep 3, 2025
If excessive foam is forming in the detergent drawer of your Sharp Washer, it could be due to using too much detergent or using the wrong type. To stop the foam, press the Start/Pause button, dilute one tablespoon of softener into 1/2 litre of water and pour into the detergent drawer. Press the Start/Pause button after 5-10 mins. Ensure you only use detergents specifically produced for automatic Washing Machines.
If you're experiencing unsatisfactory washing results with your Sharp Washer, it could be because your washing is too dirty for the selected program; use the information in the program tables to select the most appropriate program. Ensure you are using enough detergent as instructed on the packaging. Also, check that you have not exceeded the maximum capacity for the selected program.
O
Omar TaylorSep 8, 2025
How to remove detergent residue from Sharp Washer laundry?
S
Steven SanchezSep 8, 2025
If your laundry has detergent residue after washing in your Sharp Washer, non-dissolving particles of some detergents may appear on your laundry as white spots. Perform an extra rinse, or clean your laundry with a brush after it dries.