EasyManua.ls Logo

Sharp ES-NFB914AWB-EE - User Manual

Sharp ES-NFB914AWB-EE
44 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ИНСТРУКЦИЯ
Sharp ES-NFB914AWB-EE

Table of Contents

Questions and Answers

  • T
    Teresa Young DDSAug 17, 2025
    Why my Sharp Washer doesn't start?
    • Z
      zwebbAug 17, 2025
      Your Sharp Washer might not start due to several reasons: it might not be plugged in, the fuses could be faulty, there might be no mains power supply, the Start/Pause button might not be pressed, the program dial might be in the ‘stop’ position, or the machine door might not be completely closed. Ensure the machine is plugged in, check and replace the fuses if necessary, verify the mains power supply, press the Start/Pause button, turn the program dial to the desired position, and ensure the door is completely closed.
  • H
    harrelldavidAug 20, 2025
    How to fix a Sharp ES-NFB914AWB-EE Washer that does not discharge water?
    • H
      hernandezbenjaminAug 20, 2025
      If your Sharp Washer isn't discharging water, check the drain hose for clogs or twists; clean or untwist it as needed. Also, the pump filter might be clogged, so clean that as well. Ensure that your laundry is spread evenly inside the drum.
  • B
    Brittany EstradaAug 22, 2025
    Why Sharp Washer spin cycle delayed or not working?
    • A
      Andrew WhiteAug 22, 2025
      If the spin cycle in your Sharp Washer is delayed or not taking place, it may be because the Unbalanced Load Control system has been activated. This system will attempt to spread your laundry evenly. The spinning cycle will begin once your laundry is spread. For the next wash, load the drum evenly.
  • A
    amyramirezAug 26, 2025
    What causes unsatisfactory washing results with a Sharp ES-NFB914AWB-EE when using hard water?
    • A
      Amber AndersonAug 26, 2025
      If you're experiencing unsatisfactory washing results with your Sharp Washer and you have hard water, increase the amount of detergent following the manufacturer’s instructions. Also, ensure that your laundry is spread out in the drum.
  • E
    Erik CarlsonAug 28, 2025
    What to do if my Sharp ES-NFB914AWB-EE Washer does not intake water?
    • D
      Destiny ParkerAug 28, 2025
      If your Sharp Washer isn't taking in water, there are a few things you can check. First, make sure the water tap is turned on. Then, inspect the water inlet hose to ensure it's not twisted. Also, the water inlet hose or inlet filters may be clogged. Clean the water inlet hose filters and the inlet filters. Finally, ensure the machine door is completely closed.
  • A
    Alexandra DavisAug 30, 2025
    Why is my Sharp Washer vibrating so much?
    • C
      Cynthia WestAug 31, 2025
      If your Sharp Washer is vibrating excessively, it could be due to several reasons. The feet may not be adjusted properly, so adjust them. The transit bolts, which are fitted for transportation, might not have been removed; remove them. Ensure that your machine is not overloaded and that the laundry is spread evenly in the drum. Also, avoid setting up your washing machine on a hard surface.
  • J
    Jamie GreenSep 2, 2025
    Why Sharp ES-NFB914AWB-EE leaves unsatisfactory washing result?
    • D
      Deborah MccarthySep 2, 2025
      An unsatisfactory washing result from your Sharp Washer can occur for several reasons. Your washing might be too dirty for the program you selected; refer to the program tables to choose a more appropriate program. You might not be using enough detergent; use the amount instructed on the packaging. Also, there might be too much laundry in your machine; ensure you haven't exceeded the maximum capacity for the selected program.
  • T
    turnerpamelaSep 5, 2025
    How to reduce excessive foam in Sharp Washer detergent drawer?
    • H
      hraymondSep 5, 2025
      Excessive foam in the detergent drawer of your Sharp Washer is usually caused by using too much detergent or using the wrong type of detergent. To stop the foam, press the Start/Pause button, dilute one tablespoon of softener into 1/2 litre of water, and pour it into the detergent drawer. Press the Start/Pause button again after 5-10 minutes. Only use detergents specifically produced for automatic washing machines.
  • D
    David CantrellSep 7, 2025
    Why does Sharp Washer discharge water immediately after loading?
    • K
      Kyle ManningSep 8, 2025
      If your Sharp Washer discharges water as soon as it's loaded, it's likely because the end of the water drain hose is too low. Check that the drain hose is at a suitable height.
  • P
    Paul CortezSep 12, 2025
    How to remove detergent residue from Sharp ES-NFB914AWB-EE Washer laundry?
    • J
      James RoySep 12, 2025
      If your laundry has detergent residue after washing in your Sharp Washer, it's likely due to non-dissolving particles in some detergents appearing as white spots. To resolve this, perform an extra rinse cycle, or clean your laundry with a brush after it dries.

Sharp ES-NFB914AWB-EE Specifications

General IconGeneral
TypeFront Load
Capacity9 kg
Energy Efficiency ClassA+++
Spin Speed1400 RPM
ColorWhite
Water Consumption50 L

Related product manuals