Why are there grey spots on my laundry after washing in my Sharp ES-NFB814BWNA-EN Washer?
If grey spots appear on your laundry after washing in your Sharp Washer, it's likely due to untreated oil, cream, or ointment on the items. In the next wash, use the amount of detergent as instructed on the packaging.
How to fix Sharp ES-NFB814BWNA-EN that does not discharge water?
If your Sharp Washer isn't discharging water, check the drain hose for clogs or twists; clean or untwist it as needed. Also, the pump filter might be clogged, so clean the pump filter. Ensure that the laundry is spread evenly in the machine.
Why won't my Sharp Washer start?
If your Sharp Washer doesn't start, several factors could be at play. Ensure the machine is properly plugged in and that the fuses are in good working order; replace them if necessary. Verify that there is a stable mains power supply. Don't forget to press the Start/Pause button and confirm that the program dial is set to your desired position. Finally, make sure the machine door is fully closed.
What to do if my Sharp ES-NFB814BWNA-EN Washer does not discharge water?
If your Sharp Washer isn't draining water, the drain hose might be clogged or twisted; inspect it, and either clean or untwist it. Another potential issue is a clogged pump filter, which should be cleaned. Also, if the laundry is too tightly packed in the drum, redistribute it evenly.
What to do if Sharp ES-NFB814BWNA-EN does not intake water?
If your Sharp Washer isn't taking in water, start by checking if the water tap is turned on. Inspect the water inlet hose for any twists and untwist it if necessary. Also, the water inlet hose or inlet filter may be clogged, so clean the water inlet hose filters and the inlet filters. Lastly, ensure that the machine door is completely closed.
Why does my Sharp ES-NFB814BWNA-EN discharge water immediately after loading?
If your Sharp Washer immediately discharges water as soon as it's loaded, the end of the water drain hose might be positioned too low. Check that the drain hose is at a suitable height.
How to reduce foam in my Sharp ES-NFB814BWNA-EN detergent drawer?
If you notice excessive foam in the detergent drawer of your Sharp Washer, it's likely due to using too much detergent or using the wrong type. To stop the foam, press the Start/Pause button, then dilute one tablespoon of softener into 1/2 litre of water and pour into the detergent drawer. Press the Start/Pause button again after 5-10 minutes. Ensure you only use detergents specifically produced for automatic Washing Machines.
What to do if my Sharp ES-NFB814BWNA-EN Washer is not cleaning well in hard water?
If you're experiencing unsatisfactory washing results with your Sharp Washer, especially in areas with hard water, try increasing the amount of detergent according to the manufacturer’s instructions. Also, make sure your laundry is spread out in the drum.
Why is my Sharp Washer not cleaning clothes properly?
If you're not satisfied with the washing results from your Sharp Washer, consider whether your laundry is too dirty for the selected program. Refer to the program tables to choose a more suitable program. Also, ensure you're using enough detergent as instructed on the packaging, and that you're not overloading the machine beyond the maximum capacity for the selected program.
Why is my Sharp ES-NFB814BWNA-EN Washer not taking in water?
If your Sharp Washer isn't taking in water, start by checking if the water tap is turned on. Inspect the water inlet hose for any twists and untwist if necessary. Also, the water inlet hose or inlet filter may be clogged, so clean these filters. Lastly, ensure that the machine door is completely closed.
Provides essential safety advice for operating the washing machine.
Details important precautions and guidelines for using the washing machine.
Details on how to correctly connect the washing machine to the power supply.
Step-by-step guide for connecting the water inlet hose properly.
Instructions on how to connect the water drain hose correctly.
Instructions on sorting, checking, and preparing clothes before washing.
Crucial information on selecting and adding the correct amount of detergent.
Identifies common fault codes and provides corresponding troubleshooting steps.
General| Door color | Black, Silver |
|---|---|
| Door hinge | Left |
| Motor type | Brushless |
| Water fill | Cold |
| Cord length | 1.655 m |
| Drum volume | 51 L |
| Control type | Buttons, Rotary |
| Display type | LED |
| Door opening | Side opening |
| Loading type | Front-load |
| Certification | CE |
| Drum material | Stainless steel |
| Product color | White |
| Reversible doors | No |
| Country of origin | Turkey |
| Inlet hose length | 1.47 m |
| Door opening angle | 180 ° |
| Outlet hose length | 1.8 m |
| Appliance placement | Freestanding |
| Display illumination | Yes |
| Package depth | 577 mm |
| Package width | 641 mm |
| Package height | 881 mm |
| Package weight | 65500 g |
| Current | 10 A |
| Connected load | 2200 W |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 Hz |
| Energy efficiency scale | A to F |
| Power consumption (off) | 0.5 W |
| Power consumption (standby) | 1 W |
| Water consumption per cycle | 48 L |
| Energy consumption washing per cycle | 0.47 kWh |
| Drum capacity | 8 kg |
| Cycle time (max) | 218 min |
| Delay start (max) | 23 h |
| Residual moisture | 53 % |
| Spin-drying class | B |
| Maximum spin speed | 1400 RPM |
| Minimum spin speed | 800 RPM |
| Noise level (spin) | 76 dB |
| Noise level (wash) | 50 dB |
| Number of washing programs | 15 |
| Add garment (pause) function | - |
| Cycle time (quick washing program) | 15 min |
| EAN | 4550556103848 |
| Net weight | 60500 g |
| Annual water consumption washing | 10224 L |
| Annual energy consumption washing | 155 kWh |
| UK Trade Tariff code | 8450 |
| Paper packaging weight | 410 g |
| Plastic packaging weight | 849 g |
| Customs product code (TARIC) | 8450119000 |
Weight and Dimensions| Depth | 527 mm |
|---|---|
| Width | 597 mm |
| Height | 845 mm |
| Weight | 65300 g |
| Gross weight | 66500 g |
To Next Page