EN - 18
programme.
Toselectthisfunction,presstheRapid
wash button when the symbolis
displayed.
NOTE: If you put less than
halfthemaximumloadoflaundryinto
yourmachinethehalf-loadfunctionwill
beautomaticallyset,regardlessofthe
programmeyouselected.Thismeans
thattheselectedprogrammewilltakeless
timetocompleteandwilluselesswater
andenergy.Whenyourmachinedetects
half load, the symbolisdisplayed
automatically.
10. No Spin(*)
Auxiliaryfunctionbutton4 or 5 NoSpin
If you don’t want to perform wringing on
your laundry, you can use this auxiliary
function. You may make the programme
active by pressing the wringing cancel
button on the display panel when the led
light of the symbol turns on.
11. Cold Wash(*)
Auxiliaryfunctionbutton4 or 5 Cold Wash
Youcanusethisauxiliaryfunctionwhen
youwanttowashyourlaundrywithcold
water (tap water). You may make the
programmeactivebypressingthecold
washingbuttononthedisplaypanelwhen
theledlightofthe symbol turns on.
(*)Machineryspecificationsmayvary
dependingontheproductpurchased.
Start/Pause button
BypressingontheStart/Pausebutton,
you may start the programme you
haveselectedorsuspendarunning
programme.Ifyouswitchyourmachineto
the standby mode, the Start/Pause led on
theelectronicdisplaywillblink.
5.8 Child Lock
The Child Lock function allows you to
lock the buttons so that the wash cycle
you have chosen cannot be changed
unintentionally.
To activate child lock, press and hold
button 4 and 5 simultaneously for at
least 3 seconds. ‘’CL’’ will flash on the
electronic display for 2 seconds when the
child lock is activated.
If any button is pressed or selected
programme is changed by the programme
dial while the child lock is active, the “CL”
symbol will flash on the electronic display
for 2 seconds.
If the child lock function is active and
a programme is running, when the
programme dial is turned to the CANCEL
position and another programme
is selected the previously selected
programme continues from where it was
left.
To deactivate the child lock, press and
hold button 4 and 5 simultaneously for at
least 3 seconds until the “CL” symbol on
the electronic display disappears.