Sharp GF-777H - Specifications; Power Supply

FOR A COMPLETE DESCRIPTION OF THE OPERATION OF THIS UNIT,
PLEASE REFER TO THE OPERATION MANUAL
SPECIFICATIONS
GENERAL
TAPE
RECORDER/PLAYER
Power
source:
AC
110/220/240V
,
50/60Hz
Tape:
Philips-type
compact
cassette
tape
DC 15V (UM/SUM-1, R-20, HP-2, Frequency response: 30Hz to 18000Hz (Metal tape)
or “D’’ battery x 10, or external 30Hz to 17000Hz (CrO, tape)
DC supply) 30Hz to 14000Hz (normal tape)
Speakers:
Super
Woofer;
16cm
(6-1/2")
x2
S/N
ratio:
56dB
(SNRS:
ON,
METAL
TAPE)
Woofer; 16cm (6-1/2") x 2 Wow and flutter (DIN 45511):
Tweeter; Horn type x 2 0.14%
Output
power:
(GF-777H)
(DIN
45324)
Input
sensitivity
and
input
impedance:
MPO 28W, AC supply operation, Ext. Mic; 600 ohms
with four amplifiers Mixing mic; 600 ohms
RMS 24W, DC supply operation, Line in; 0.1V/100k ohms
with four amplifiers Output level and loaded impedance:
(GF-777E)
MPO
45W,
AC
supply
operation,
Headphones;
8
ohms
to
25
ohms
with
four
amplifiers
External
speaker;
4
ohms
to
8
ohms
RMS
24W,
DC
supply
operation,
Line
out;
0.6V/47k
ohms
with four amplifiers
Semiconductors:
17-IC’s
RADIO
52-Transistors Frequency range: LW; 150 —285kHz
1-FET
MW;
520
—
1620kHz
1-SCR
SW;
5,95
—
18MHz
61-Diodes
FM;
87,6
—
108MHz
11-LED’s
Dimensions: Width; 752mm
Depth; 166mm
Height; 379mm
Weight (without batteries): 12.2kg
POWER SUPPLY
The GF-777H/E Unit will operate on an AC mains supply of
110 Volts, 220 Volts, or 240 Volts of 50Hz or 6OHz. For
portable use it will operate on its internal batteries, or from an
external 15 Volts DC supply (with an adaptor).
AC
SUPPLY
VOLTAGE
ADJUSTMENT
The Voltage Selector setting should be checked to see that it
conforms to the local AC supply voltage. This must be done
before plugging in to the AC supply. Adjustment is made by
turning the adjusting screw in either direction with a minus
headed screwdriver until reading of Selector matches the local
AC supply voltage.
Caution:
Use this unit only on the specified voltages, otherwise
damage, fire, or accidents may be caused. SHARP cannot
accept responsibility for any damage resulting from the use
of this unit on unspecified voltages.