Sharp HT-SB30D - General Control Operations; Basic Functions and Settings; Sound Modes and Input Selection

E-13
General control
■ To turn the power on
Press the ON/STANDBY button.
The INPUT indicator lights up.
Note:
If the power does not turn on, check whether
the power cord is plugged in properly.
To set the sound bar to standby mode:
Press the ON/STANDBY button again. The
PAIRING indicator turns BLUE.
■ Bluetooth standby mode
● The rst time the unit is plugged in, it
will enter the Bluetooth standby mode
(PAIRING indicator turns BLUE) .
● To cancel the Bluetooth standby mode,
press and hold the ON/STANDBY button
during Bluetooth standby mode. The unit
will enter the low power consumption
mode (PAIRING indicator turns off).
● To return to the Bluetooth standby mode,
press the ON/STANDBY button again.
● During Bluetooth standby condition, NFC
function is activated once your device
touches the NFC detection area or the
supplied NFC tag.
■ Volume auto fade-in
If you turn off and on the sound bar again,
volume will start at lower level and gradually
increase to the last set level.
■ Volume control
Sound bar operation:
Press volume up (VOLUME + ) to increase the
volume and press volume down (VOLUME – )
to decrease the volume.
Remote control operation:
Press the VOL + button to increase the volume
and the VOL – button to decrease the volume.
Notes:
● When volume is maximum or minimum the
SURROUND indicator blinks 3 times
● To increase or decrease the volume
continuously, press and hold the VOLUME
+/- buttons (main unit) or VOL +/- buttons
(remote control).
■ Muting
The volume is muted temporarily when
pressing the MUTE button on the remote
control (SURROUND indicator blinking).
Press again to restore the volume.
■ Surround
When the SURROUND button is pressed,
the SURROUND sound is ON. (SURROUND
indicator lights up (ORANGE))
■ Sound Mode
Remote control operation:
Press the desired sound mode button on the
remote control.
The SURROUND indicator blinks once
CINEMA (for cinema sound effect)
MUSIC (for standard sound effect)
NEWS (for news)
BYPASS (for at sound effect)
■ Function
When the INPUT button is pressed, the input
source will change.
1 Optical In Function - the INPUT indicator
turns green.
2 Audio In Function - the INPUT indicator
turns cyan.
3 Bluetooth Function - the INPUT
indicator turns blue.
Note:
The backup function will protect the
memorized function mode for a few hours
should there be a power failure or the AC
power cord becomes disconnected.