Sharp HT-SL75 User Manual

E-10
2011 October 7
HT-SL70 ZB056
10
9
8
7
6
5
4
3
2
1
General Control
Plug the AC power lead into a wall socket, the stand-by
indicator turns RED.
This unit will automatically power on if:
1. TV or similar component which supports HDMI CEC, is
turned on.
2. Audio signal is detected from Audio input.
The stand-by indicator will turn BLUE if TV signal is
detected.
Notes:
● HDMI input will override the Audio input signal.
● Audio input will function only when there is no signal
from HDMI input.
● A slight audio delay after TV is turned ON does not
mean that the system is faulty. This is normal.
● “AQUOS speaker is enabled” message will be
displayed if SHARP LCD TV does not detect HT-SL70/
HT-SL75 during power on. However the message
“AQUOS audio with AQUOS LINK is enabled” will be
displayed soon as HT-SL70/HT-SL75 is detected.
These messages may vary for other TV model.
The Audio Return Channel (ARC) enables an HDMI ARC-
capable TV to send the audio stream to the HDMI OUT
terminal of the receiver. To use this function, your TV must
support the ARC. Make sure the LCD TV Audio output
setting is set to PCM, not other formats such as Dolby
Digital, DTS, etc. For details, refer to the operation manual
of the TV.
Volume can only be controlled from your TV.
This unit will automatically go to stand-by mode (indicator
turns RED) if:
1. TV or similar component which supports HDMI CEC, is
turned off.
2. No signal from Audio input is detected after 20 minutes.
Make sure to enable the HDMI CEC when making HDMI connection. For details, refer to the operation manual
of the TV.
■ To turn the power on
■ Audio Return Channel (ARC) (Audio
Return Channel submenu)
■ Volume
■ Power Off

Sharp HT-SL75 Specifications

General

Brand	Sharp
Model	HT-SL75
Category	Speakers
Language	English