Sharp IM-DR420H

E-36
IM-DR420H
ENGLISH
03/7/21 IM-DR420H_SEEG_E.fmIM-DR420H TINSZ0964AWZZ
Advanced Features
-Titling a MiniDisc-
Master MiniDisc operation Operation of the MiniDisc for stamping
Note:
If the total number of tracks on the master MiniDisc does
not match that on the MiniDisc for stamping, the unit will
display "Can'tSTAMP" and turn off.
If this happens, adjust the total number of tracks on the
newly recorded MiniDisc using the edit operation.
1
Insert a master MiniDisc.
Do not mistake the master MiniDisc for the target one.
2
Whilst in the stop mode, press the MENU/ENTER but-
ton.
3
Press the or button repeatedly to select "EDIT".
4
Press the MENU/ENTER button.
5
Press the or button
repeatedly to select "NAME
STAMP".
6
Press the MENU/ENTER
button.
To cancel the operation, press the :OFF/HOLD button.
7
Press the MENU/ENTER button.
8
When the unit displays "CHANGE MD", remove the
master MiniDisc.
Remove it without turning off the power. Or, the operation
will be cancelled.
9
Load a MiniDisc for stamping.
10
Press the MENU/ENTER button.
The unit will finish recording the character information and
enter the stop mode.