EasyManua.ls Logo

Sharp KH-6V08FT00-EU - Key Lock

Sharp KH-6V08FT00-EU
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN -13-
Touching and sets the timer val-
ue for the heater.
Thetimerrunningfortherstsetheater
timer is indicated by the lit cooking zone
indicator.
Touching once again assigns other
timers to other activated heaters.
10 sec after the last operation, the timer
displaychangestothetimerthatwilln-
ish next.
The assignment of that timer is always
displayed by a ashing cooking zone
indicator. The cooking zone indicator
shows how many timers are on at any
one time.
By toggling , you can display the tim-
er values for the heater timer and the
minute minder. The assignment is al-
waysindicatedbytheashingcooking
zone indicator. If no cooking zone indi-
catorashes,theminutemindertimeis
shown in the 2-digit timer display.
All heater timers can be erased by
switching off the appliance into the S
mode using . A minute minder will not
be erased. It will continue with the op-
eration until time is up.
To erase a timer in operation mode, you
rsthavetoselectthetimerbytoggling
the Active/Deactivated timer button until
it is displayed. The value can then be
erased 2 different ways:
· Decrement by touching until ´00`
appears on the Timer Display.
· Touch and simultaneously for
0.5 sec until ´00` is shows on the timer
display.
After reaching the ´00` on a heater tim-
er, the assigned heater level will be set
to ´0`.
A buzzer will signal that the heater timer
orminuteminderhasnishedcounting
down to 0. Erase by touching any but-
ton for acknowledgement.
Wait until ‘F’ disappears for all zones,
then turn the hob on by touching and
continue to use.
Key Lock
Key lock functionality is for blocking and
set the appliance into a save modus
during operation. Touch modications
as for example rise heat settings and
others should not be possible. It is only
possible to switch the appliance off.
The lock function is active, if the Key
Lock button is pressed at least 2
sec. This operation is acknowledged by
a buzzer. After successful operation of
more than 2 sec, the key lock indicator
ashesandtheheaterislocked.
The heater can only be locked in oper-
ating mode (B mode).
If the heater is locked, only can be
operated; all other buttons are blocked.
If any other button is operated in the
blocked mode, the buzzer signal sounds
andthekeylockindicatorashesasin-

Related product manuals