13
REMOVE OF LID COVER
REMOVE OF LID ASS’Y
1. Remove the lid ass’y in accordance with “REMOVE OF LID ASS’Y”.
2. Push the both sides of the lid assembly outward at the claws A , B , C . Unlock the lid from claw D
by pull the lid up.
3. Pry 6 claws of the holder plate ass’y from the lid cover.
4. Turning the holder plate ass’y counterclockwise.
5. Now the lid cover is free.
1. Remove the lid cap from the unit.
2. Remove the body in accordance with “REMOVE OF BODY”.
3. Remove the screw holding the hinge cover.
4. Disconnect lead wire (Lid heater) from PCB ass’y and remove the screw holding lead wire earth from
outer pot.
5. First release the latch button and open it to a normal degree.
6. Remove the lid ass’y from the panel ring.
7. Now the lid ass’y is free.
PCB ass’y
Inner lid lead wire connector
Fig. 2
Fig. 3
Lid cover
Claw of lid heater
Screw
Outer pot
Earth lead wire
B
C
A
A
B
C
D
Claw
Lid
Claw
Claw
Claw
Lid
Remove lid ass’y
Panel ring
To Next Page
Loading...
