Sharp LC-13S1E User Manual

14
LC-13S1E
LC-15S1E
4. Initialization
When the microprocessor (IC2001) or the EEPROM (IC2007, IC2009) has been replaced or when the EEPROM
has been initialized, readjust the each adjustments.
4-1. Connect the pins (81) and (82) of IC2001 (microprocessor) to GND, and turn on the power.
4-2. Check that the model name is (A661).
4-3. Select the inch size (13) : (LC-13S1E) and (15) : (LC-15S1E).
4-4. LED changes green from red after setting finish and about 15 seconds, initialization is completed, and it
becomes adjustment mode.
4-5. Writing the model-by-model data
For the Ver.1.00A microprocessor, get it initialized first and then make the settings, listed below, on it. (The
microprocessor version is indicated at the bottom of Adjustment Process Page 1.)
Ver.1.00A data reprogramming (INCH SIZE [13]) (LC-13S1E / E(K) / E(R))
Adjustment process page
12
47
47
–
Item
PAL TV PKCFSOFT7C
PAL TV LDLY
PAL AV LDLY
DPS 2DH
OSD settings
6 → 4
0 → +1
0 → +1
–
Ver.1.00A data reprogramming (INCH SIZE [13]) (Only for LC-13S1E(K))
Adjustment process page
12
11
11
11
11
11
Item
PAL TV PKCFSOFT7C
PAL TV COLOR
PAL AV COLOR
PAL TV TINT
PAL AV TINT
PAL BRIGHTNESS
OSD settings
4 → 6
41 → 37
41 → 37
–2→ +1
–2→ +1
–15→ –3
Ver.1.00A data reprogramming (INCH SIZE [15]) (LC-13S1E / E(K) / E(R))
Adjustment process page
11
11
11
11
12
47
47
Item
PAL BRIGHTNESS
PAL-M BRIGHTNESS
PAL-N BRIGHTNESS
PAL60 BRIGHTNESS
PAL TV PKCFSOFT7C
PAL TV LDLY
PAL AV LDLY
OSD settings
0 → –8
0 → –8
0 → –8
0 → –8
6 → 4
0 → +1
0 → +1
Ver.1.00A data reprogramming (INCH SIZE [15]) (Only for LC-15S1E(K))
Adjustment process page
11
11
11
11
12
Item
PAL TV COLOR
PAL AV COLOR
PAL TV TINT
PAL AV TINT
PAL TV PKCFSOFT7C
OSD settings
38→ 37
38→ 37
–2→ +1
–2→ +1
4 → 6

Sharp LC-13S1E Specifications

General

Brand	Sharp
Model	LC-13S1E
Category	LCD TV
Language	English