LC-32R24B
3 – 11
6. Special features
* STANDBY CAUSE (Page 1/33)
Display of a cause (code) of the last standby
The cause of the last standby is recorded in EEPROM whenever poss ble.
Checking this code will be useful in finding a problem when you repair the troubled set.
* EEP SAVE (Page 33/33)
Storage of EEP adjustment value
* EEP RECOVER (Page 33/33)
Retrieval of EEP adjustment value from storage area
7. Code list for Standby Cause
32
1 KEY LOCK (1217)
2 KOUTEI AREA ALL CLEAR
3 A MODE AREA CLEAR
4 BACKUP AREA CLEAR
5 B MODE AREA CLEAR
6 EXECUTION
33
1 EEP SAVE Writing setting values to EEPROM.
2 EEP RECOVER Reading setting values from EEPROM.
3 STANDBY CAUSE RESET Reset stand by cause.
4 SETTING FOR ADJ
5 PANEL SIZE
Code Indication Description
1 RC_STNBY /* Standby set by remote control */
2 NO_OPERT /* Off caused by no operation */
3 NO SIGNA /* Off caused by no signal */
4 PC_MODE1 /* Set by the PC power management mode 1 */
5 PC_MODE2 /* Set by the PC power management mode 2 */
6 SLEEP TM /* Set by off timer */
8 OFF_232C /* Set by the command from RS232C */
9 AVC_TACT /* Set by the front switch at the AVC center */
A BSBOOKED /* The pre-set time has passed since TV was turned on from standby by the BS timer. */
B E_MONIPW /* Monitor main power failure detected */
10 E_CCKMVT /* Abnormal voltage of CCKM line detected */
11 OUT_OF_R “/* While a PC display is on, unspecified input continued long time. */”
12 E_NOMONI /* Incompatible monitor is connected to the AVC center. */
14 E_AVCFAN /* Fan failure at the AVC center */
15 E_BSSUBM /* Communication failure with the BS sub microcomputer (Not used) */
16 E_CVICIC /* CVIC failure */
17 E_AVCTMP /* Abnormal temperature at the AVC center */
18 E_1BITAU /* 1Bit-AMP failure */
1A E_MONITR /* Monitor problem detected */
1B E_FNLOCK /* Fan lock for North America */
40 E_DSDEV /* Failure in Digital Standby */
Page Line Item Description Remarks (adjustment detail, etc.)
Leandro Palmeira
eletronicagaucho@hotmail.com
To Next Page
Loading...
