49
• One USB ash disk
6.2.3 Upgrade Introduce
Copy the upgrade le into the USB Flash Disk.
Insert the USB Flash Disk Into the USB PORT of 6486 board.
Turn On your 6486 board.
If the upgrade le is correct, the software will begin upgrade automatically.
6.2.4 Upgrade interface
Upgrade interface
• Durning upgrade process, screen will display upgrade progress information, and please do
not turn o your TV, it will reboot automatically while the upgrade is complete.
• 100% mean the upgrade is complete,then pull out USB storage and restart TV.
• Error mean upgrade fail. If upgrade fails, please turn o your TV and try to upgrade again.
Led ash mode
Durning upgrade process, we can know about the upgrade status from the LED ash mode.
During upgrade
RED 1000ms GREEN 1000ms ashing, until upgrade succeed or fail.
Upgrade succeed
RED 250ms GREEN 250ms ashing, Long time to blink until power o.
Upgrade fail
RED 1750ms GREEN 250ms ashing, Long time to blink until power o.
To Next Page
Loading...
Need help?
General