Sharp LC-40LE265T - Adjustment Procedures (LC-32 LE265 T); LC-32 LE265 T Adjustment Steps and Mode Operation

LC-32LE265T / LC-40LE265T
3 – 11
[2] ADJUSTMENT ( LC-32LE265T )
[1] ADJUSTMENT PROCEDURE
1.Entering and cancel the adjustment process mode
1)While holding down the POWER and CENTER keys at the same time,plug in
the AC cord to turn the power.
2).Backlight turned ON,screen disply show Black pattern and LED blinking GREEN --> RED -->
GREEN -->RED.
3)Enter password “UP ( CH UP )-->DOWN (CH DOWN )--> UP (CH UP )”. (After 30 sec password not
keyed in or password keyed in wrong, go to previous Power Status (On,Stand by or OFF ).
4).Backlight turned On , screen display show Purple test pattern ( LED still blinking GREEN -->
RED -->GREEN --> RED )
5).Press the Center Key . ( The adjustment process mode screen appears. )
6).After run function, LED light to GREEN.
7).To cancel it, turn o the power using the POWER switch or remote control .
2.Remote controller Key operation and description of disply in adjustment process mode.
1.Key Operation
Remote controller Key JOY Key &ƵŶĐƟŽŶ
CH ( / ) - Changing channel (UP/DOWN)
VOL ( + / - ) - Changing volume (UP/DOWN)
Cursor ( / ) UP/DOWN Turning a page (PREVIOUS /NEXT)
Cursor ( / ) LEFT/RIGHT Changing a selected line ƐĞƫŶŐ (+10 /-10 )
INPUT ďƵƩŽŶ or remote
CENTER
Input source switching (toggle switching )
controller
CENTER
Input
source
switching
(toggle
switching
)
(ATV --> AV -->Component -->PC RGB )
ENTER - Enter
* Input mode is switched ĂƵƚŽŵĂƟĐĂůLJ when relevant adjustment is started so far as the ŶĞĐĞƐƐĂƌLJ input signal is available .