LC-32LE265T / LC-40LE265T
3 – 20
4.Public Mode Menu 
The guidance is not displayed onscreen .
Setup procedure 
To move the cursor up and down ,use the "cursor UP/DOWN Key (remote controller )and "CH (UP )/(DOWN )"Key  (remote controller and set ).
To change the ƐĞƫŶŐƐƵƐĞ the "cursor RIGHT/LEFT "Key (remote controller )and (RIGHT /LEFT) local key.     
To save new ƐĞƫŶŐƐŬĞĞƉ the cursor at"Exucute"and use the "cursor RIGHT/LEFT"Key (remote controller )  
       
< Example of image >
1) POWER ON MODE SELECT 
 "VARIABLE","FIXED_ALL","FIXED_BODYKEY"or "RC RESPOND"( loop enable )
 "VARIABLE "
&ƵŶĐƟŽŶƐ
VARIABLE                        : "POWER/RECEPTION"Key on TV unit or remote control is enabled.
FIXED_ALL                       : "POWER/RECEPTION"Key on TV unit or remote control is disabled.
FIXED_BODYKEY       : Only the "MAIN POWER"Key on TV unit is disabled ( The remote control is enabled )                  
RC RESPOND            : The main unit's POWER switch toggles between ON and standby ( the same ŽƉĞƌĂƟŽŶ by                  
                                                     the remote control ).
OFF TIMER (SLEEP) (*Only when ƐĞƫŶŐ to FIXED_ALL )
KƉƟŽŶ 
Default 
Key disabled when set 
When ƐĞůĞĐƟŶŐ to Η&/yͺ>>ΗĨƵŶĐƟŽŶ related standby factors (see below ) doesn't work ,and not ƐĞůĞĐƟŶŐ 
       OFF TIMER (Sleep)
       No ŽƉĞƌĂƟŽŶ OFF 
       No signal OFF (including the power management )
These items does not exist according to the model .
If the power is pressed in the ordinary more in ƐĞƫŶŐ to "FIXED_ALL" and "FIXED_BODYKEY",the ĐĂƵƟŽŶ is displayed for 5 seconds.
When power ďƵƩŽŶ on the main unit is pressed  When power ďƵƩŽŶ on R/C is pressed 
other than default 
Remark
2.SHUT DOWN MODE 
This ĨƵŶĐƟŽŶ decides wheather scanning digital tuner is enable or disabled when the power is standby.
džƉůĂŶĂƟŽŶ 
No Power Žī by power ďƵƩŽŶ . No Power Žī by remote control. 
KƉƟŽŶ
"NORMAL " or "QUICK"
LAMRONtluafeD
      NORMAL            : Scanning digital tuner is enabled when power is standby.
      QUICK                 : Scanning digital tuner is disable.
                 It is possible to put into the standby state instantaneously due to power Žī input,when the 
                 power is standby.
                                     Immediately,state is a complete standby.
In ƐĞůĞĐƟŶŐ "QUICK",the ĨƵŶĐƟŽŶ does not work for the following items ;ƐĞůĞĐƟŽŶ impossible .)
    ON TIMER ,QUICK START ,DIGITAL FIXED ,etc.
          *These items does not exist acording to the model .
Remarks