Sharp MD-M1 - Preset Tuning and Memory; Preset Memory Scan; Erasing Memorized Stations

19
(Continued)
2,4
2,4
3
3
■ Preset tuning
You can store up to 40 stations in memory (40 sta-
tions consisting of any combination of AM and FM
stations you like) and recall them.
To enter stations into memory:
1 Perform steps 1 - 5 in the "Tuning" section.
2 Press the MEMORY button.
MEMORY
MEMORY
3 Within 5 seconds, press the PRESET (X or W)
button to make the preset channel number flash
in the display.
MEMORY
● Store the stations in memory, in order, starting
with preset channel 1.
When
is displayed, a station has already been
stored in this preset number memory.
4 Within 5 seconds, press the MEMORY button
to store that station in the selected station pre-
set number memory.
MEMORY
MEMORY
● If the "MEMORY" and preset number indicators
go out before the station is memorized, repeat
the operation from step 2.
5 Repeat steps 1 - 4 to set other preset stations,
or to change a preset station.
● When a new station is stored in the selected sta-
tion preset number memory, the contents previ-
ously memorized will be erased.
1 To scan the preset stations, press the PRESET
(X or W) button for more than 0.5 seconds.
● The station preset number will flash and the pro-
grammed stations will be tuned in sequentially,
for 5 seconds each.
2 Press the PRESET (X or W) button again to
stop the memory scan at the desired station.
Note:
When the preset memory does not have any sta-
tions stored in it, the preset memory scan will not
function.
To erase all memorized stations:
When the unit is in the stand-by mode, hold and
press the TUNER and TUNING X buttons, and then
press the POWER button.
● "PRESET CLR" will appear.
To erase the memorized station:
1 Recall the memorized station to erase by press-
ing the PRESET button.
2 Press the CLEAR button.
● "MEMORY" and preset number will flash.
3 Within 5 seconds, press the MEMORY button.
4 Repeat steps 1-3 to erase other memorized sta-
tions.
To recall a memorized station:
Press the PRESET (X or W) button for less than
0.5 seconds to select the desired station.
● "MEMORY" will appear.
● The stations (preset channel number, frequency
and frequency band) which have been stored in
memory will appear in the display in numerical
order, irrespective of the frequency bands.
Backup function:
The backup function protects all station presets for
a few hours should there be a power failure or the
AC power cord is removed from the AC outlet.
■ Preset memory scan
The stations saved in the preset memory can be
scanned automatically.
PRESET
(X W)
PRESET
(X W)