Sharp MD-M1 - Using External Units; Connecting External Devices

34
■ Connecting external units
Before connecting external units, set this unit to the stand-by mode and turn off the power to the external
units.
Connecting to stereos or MD/CD players (equipment which can output analog signals)
The other MD/CD player
Commercially available cord
with 1/8" (3.5 mm) stereo
mini-plug and RCA plugs
To the output /
headphone jack
RIGHT
LEFT
To the analog
output jacks
LEFT
RIGHT
RIGHT
LEFT
● Red plug → To RIGHT
● White plug → To LEFT
Commercially available RCA cord
AUX
INPUT
LEVEL
RIGHT
LEFT
RIGHT
LEFT
Note:
● When the audio output signal of an external unit is connected to this unit, oscillation may occur.
In such a case, disconnect either the input or output connection.
■ Headphones
Notes:
● Before plugging in or unplugging the headphones, make sure the volume level is reduced.
● Be sure your headphones have a 1/8" (3.5mm) diameter plug and are between 16 ohms and 50
ohms impedance. The recommended impedance is 32 ohms.
● When headphones are connected, the speakers are disabled automatically.
Adjust the VOLUME control for the desired volume.
USING EXTERNAL UNITS