Sharp MD-M1 - Recording from Built-in Radio

23
3
2
3
4
4
H
H
5
5
■ Recording from the built-in radio
onto a MiniDisc
1 Tune in to the desired station. (pages 18 - 19.)
2 Load a recordable MiniDisc.
3 Press the ● REC button.
● The unit will enter the recording stand-by mode.
4 Check the recordable time by pressing the DIS-
PLAY button.
Note:
● Before recording an AM broadcast, enter the
recording stand-by mode, and then separate the
AM loop antenna from the main unit. Adjust it so
that the AM broadcast can be tuned in most
clearly.
● During recording, you cannot change the station.
5 Press the 0 6 button.
To stop recording:
Press the ■ button.
The recording will stop and the track number will
be written on the MiniDisc.
Note:
● It is not possible to pause in the recording mode.
To record the track number while record-
ing:
The recording is performed as a single track.
To identify different sections of a recording you can
increase the track number at any point during the
recording process.
To create a new track number, while in the record-
ing mode, press the ● REC button.
● The track number will increase by one, and then
the recording will continue.
(Continued)