Sharp MD-MT290H - Using with the Alkaline Battery; Inserting a Minidisc

02/12/18 MD_MT290H_UK_2.fm
11
MD-MT290H
1
2
3
4
5
6
Power Source/Preparation
-Using with the Alkaline Battery/Inserting a MiniDisc-
Using with the Alkaline Battery
z Use one commercially available alkaline battery (LR6,
"AA" size).
z Disconnect the AC adaptor.
1
Push and slide the battery cover.
2
Open the battery cover.
3
Insert an alkaline battery according to the
direction indicated in the battery compart-
ment.
4
Close the battery cover.
Notes:
z Do not replace the battery during operation.
z Do not use a nickel-cadmium battery.
z Remove the battery if the unit will not be used for long
periods of time. This will prevent potential damage
due to battery leakage.
z Installing the battery incorrectly may cause the unit to
malfunction.
Inserting a MiniDisc
1
Slide the OPEN lever to release the com-
partment door.
2
Lift up the compartment door.
3
Insert a MiniDisc.
4
Close the compartment door.
Notes:
z Do not place the MiniDisc under the holder.
z If any resistance is felt, do not force the MiniDisc into
the unit, as it may cause damage to the unit. If resist-
ance is felt, remove the MiniDisc and reload it.
z The lid cannot be opened if "TOC" is displayed; refer
to the instruction on page 15.
4321
When inserting or removing the battery, push it to-
wards the battery terminal.
3
1
Recordable Recording
prevented
When you record on a MiniDisc,
check that the erase prevention tab
is set to the "Recordable" position.
2
4
Insert according to the direction arrow.