29
(Continued)
■ EON-TI
1 Tune in the desired RDS station (when a station name
is being displayed).
EON
2 Press the EON button when "EON" appears.
● "PTY TI" and "SELECT" will appear alternately for about 6
seconds.
3 Whilst they are being displayed, select the TI (Traffic
Information) by turning the jog dial.
4 Within 4 seconds, press the PTY.TI SEARCH button.
EON
TI
● "TI" and "WAITING" will appear for 2 seconds each.
● "TI" will appear, and the unit will enter the EON-TI stand-
by mode.
5 When a TA specified starts on an ON (other network)
station, the unit will automatically switch to that sta-
tion, and "TI" will flash.
TI
6 When the traffic announcement is over, the unit will
automatically return to the original station you were
tuned to.
● If the EON button is pressed when "EON" is not displayed,
"NO EON" will appear for 5 seconds to indicate that the
unit cannot enter the EON stand-by mode.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button.
("TI" →"WAITING")
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button.
Within 4 seconds, press it again. The EON stand-by mode
will be cancelled.
● "TI" will go out.
Note:
● If neither "TP" nor "TA" appears, then even if "EON" ap-
pears, the unit cannot enter the EON-TI stand-by mode. In
this condition, if the PTY. TI SEARCH (PTY. TI) button is
pressed after TI is selected, "NO TI" will flash for 4 sec-
onds.
3
24
*23-30 00.1.13, 0:00 PM29
To Next Page
Loading...
Need help?
General
