: RF side focus gain coarse adjustment
: A-ATT (focus) tentative setting
: B-ATT (focus) tentative setting
: ABMXO measurement value display
"REPEAT" mark lighting
: LPFABO measurement value display
"REPEAT" mark lighting
: LPFEFO measurement value display
"REPEAT" mark lighting
: TCRSMIO measurement value display
"REPEAT" mark lighting
: LPFEINO measurement value display
"REPEAT" mark lighting
: EFMIO measurement value display
"REPEAT", "1" mark lighting
R F g
S a
S b
A B
DISP DISP
• In the setting display sate the value of selected digit changes in the range of "0
H
to F
H
" when
[VOL UP/DOWN] key is pressed.
However, the RF side gain setting changed in the range of "0
H
to 6
H
".
• When the [DISP] key is pressed, the display changes as follows.
• ABMAXO setting
• LPFABO setting
• LPFEFO setting
• TCRSMIO setting
• LPFEINO/EFMIO setting
• LPFFINO/EFMIO setting
: RF side TCRS gain adjustment
R C G
T C
: E-ATT (tracking) initial setting
: LPFFINO measurement value display
"REPEAT" mark lighting
: EFMIO measurement value display
"REPEAT", "1" mark lighting
: F-ATT (tracking) initial setting
S E
e i
E F
S F
f i
E F
: RF side focus gain minor adjustment
: A-ATT (focus) initial setting
: B-ATT (focus) initial setting
R F G
S A
S B
a b
: RF side pit section tracking gain adjustment
: Pit section adjustment COUT level setting
: RF side groove section tracking gain adjustment
: Groove section adjustment COUT level setting
P T G
P C H
G T G
G C H
e f
DISP DISP
DISP DISP
DISP
DISP
DISP
DISP
DISP
DISP
DISP
DISP
Continued from
the preceding page
R F G
S A
S B
A H
B H
E H
F H
T H
A L
B L
E L
F L
P-MODE
P-MODE
P-MODE P-MODE
P-MODE
• When the "STOP" button is pressed in specific menu, the TEST MODE STOP state is set.
• In the specific setting display state the setting change digit changes when the [P-MODE] key is pressed.
(In case of RF side gain setting change does not occur since there is only one digit.)
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
: RF side focus gain minor adjustment
: Gain setting
: A-ATT (focus) initial setting
: ATT setting
: B-ATT (focus) initial setting
: ATT setting
: S gain "High" A signal offset (AINO) measurement
: Measurement value
: S gain "High" B signal offset (BINO) measurement
: Measurement value
: S gain "High" E signal offset (EINO) measurement
: Measurement value
: S gain "High" F signal offset (FINO) measurement
: Measurement value
: S gain "Low" A signal offset (AINO) measurement
: Measurement value
: S gain "Low" B signal offset (BINO) measurement
: Measurement value
: S gain "Low" E signal offset (EINO) measurement
: Measurement value
: S gain "Low" F signal offset (FINO) measurement
: Measurement value
: TCRS signal offset (TCRSO) measurement
: Measurement value
• 2-digit setting
• 3-rd digit setting
1st digit (initial value)
1st digit (initial value)
2nd value
2nd value
3rd digit
To Next Page
Loading...
