EasyManuals Logo

Sharp MD-S301 Service Manual

Sharp MD-S301
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
MD-S301/S301W
– 5 –
If trouble occurs
When this product is subjected to strong
external interference (mechanical shock,
excessive static electricity, abnormal sup-
ply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction. If
such a problem occurs, do the following:
1. Unplug the AC adaptor from the AC
outlet.
2. Remove the battery.
3. Leave the unit completely unpowered
for approximately 30 seconds.
4. Plug the AC adaptor back into the AC
outlet and retry the operation.
If strange sounds, smell or smoke come
out of the unit or an object is dropped into
the unit, remove the AC adaptor from the
AC socket immediately and contact an au-
thorized Sharp service center.
Many potential “problems” can be resolved by the owner without calling a service techni-
cian. If something seems to be wrong with this product, check the following before calling
your authorized SHARP dealer or service center.
PROBLEM CAUSE
The unit does not turn
on.
Is the AC adaptor disconnected?
Is the battery exhausted?
Is the unit in the safety mode?
Has condensation formed inside the unit?
Is the unit being influenced by mechanical shock or by
static electricity?
No sound is heard
from the headphones.
Is the volume set too low?
Is the remote control unit or the headphones plugged
in?
Are you trying to play a MiniDisc with data on it
instead of a MiniDisc containing music?
When the operation
buttons are pressed,
the unit does not re-
spond.
Is the unit in the safety mode?
Is the battery exhausted?
Is the remote control unit plug or the headphone plug
inserted firmly?
Has condensation formed inside the unit?
Is the unit being influenced by mechanical shock or by
static electricity?
Some sounds are
skipped.
Is the battery exhausted?
Is the unit being subjected to excessive vibration?
TROUBLESHOOTING
When an error message is displayed on the display, proceed as follows:
Display Meaning Remedy
BLANK
Nothing is recorded. Replace the disc with a
recorded disc.
E-DISC
The disc is damaged or
the music information is
not written properly on the
disc.
Replace the disc.
E-SYS
The unit is malfunctioning
and will require service.
For service, contact your
local Sharp authorized
servicer.
E-TEMP
The temperature is too
high.
Turn off the power, and
wait for a while.
E-TOC
E-UTOC
The disc is damaged. Replace the disc.
Lo BATT
The battery has run down. Charge the rechargeable
battery or replace the
alkaline battery (or use
the AC adaptor for power).
No DISC
A disc has not been
loaded.
Load a disc.
POWER?
Improper power is being
supplied.
Use one of the specified
power sources.
?DISC
There is an error in the
signal from the disc.
Replace the disc.
ERROR MESSAGES

Other manuals for Sharp MD-S301

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sharp MD-S301 and is the answer not in the manual?

Sharp MD-S301 Specifications

General IconGeneral
BrandSharp
ModelMD-S301
CategoryMiniDisc Player
LanguageEnglish

Related product manuals