8-11
SYSTEM SETTINGS►SETTING MODE LIST
*1 When a finisher/saddle stitch finisher is installed
*2 When a finisher/saddle stitch finisher is installed and a punch module is installed
*3 When a saddle stitch finisher is installed
*4 When a folding unit is installed
*5 When a trimming module is installed
Printer Settings
U: General user; A: System administrator/Administrator
C-Fold
*4
Print Side: Inside
Fold Orientation: Open Right
No Yes
Accordion Fold
*4
Fold Orientation: Open Right No Yes
Double Fold
*4
Print Side: Inside
Fold Orientation: Open Right
No Yes
Half Fold
*4
Print Side: Inside No Yes
Trimming Width Settings
*5
No Yes
• Adjust Trimming Width 2.0 mm No Yes
X Text /Image Printing No Yes
Text Settings (Stamp) – No Yes
Custom Stamp – No Yes
Custom Watermark – No Yes
Setup Items Factory default setting U A
● Printer Settings (page 8-88)
X Condition Settings No Yes
Prohibit Notice Page Printing Enabled No Yes
Prohibit Test Page Printing Disabled No Yes
A4/Letter Size Auto Change Disabled No Yes
Bypass Tray Settings No Yes
• Enable Detected Paper Size in Bypass Tray Disabled No Yes
• Enable Selected Paper Type in Bypass Tray Enabled No Yes
• Exclude Bypass-Tray from Auto Paper Select Disabled No Yes
Job Spool Queuing Enabled No Yes
Disabling of USB Memory Direct Print Disabled No Yes
Disabling of Network Folder Direct Print Disabled No Yes
Disabling sending while printing Disabled No Yes
X Interface Settings No Yes
Hexadecimal Dump Mode Disabled No Yes
I/O Timeout 60sec. No Yes
Enable Network Port Enabled No Yes
Setup Items Factory default setting U A
To Next Page
Loading...
