19
INSTALLING THE PRINTER DRIVER / PC-FAX DRIVER
WHEN THE MACHINE WILL BE CONNECTED WITH A
USB CABLE
Administrator's rights are required to install the software.
When the software selection screen appears in step 6 of "OPENING THE SOFTWARE SELECTION SCREEN (FOR
ALL SOFTWARE)" (page 8), perform the steps below.
1
Click the [Printer Driver] button.
2
Click the [Custom installation] button.
3
When you are asked how the printer is
connected, select [Connected to this
computer] and click the [Next] button.
4
When you are asked if you wish to
install the display fonts, select an
answer and click the [Next] button.
• Make sure that a USB cable is not connected to your computer and the machine.
If a cable is connected, a Plug and Play window will appear. If this happens, click the [Cancel] button to close the window
and disconnect the cable.
• The printer expansion kit and PS3 expansion kit are required to use the PS printer driver or the PPD driver.
• The printer expansion kit is required to use the PCL printer driver.
• Depending on the models, the printer expansion kit and the PS3 expansion kit are installed as standard.
• Depending on the models, Sharp Advanced Printing Language-c printer driver may not be available.
• To use the port created when the printer driver is installed for fax data transfer, install the printer driver first and then install
the PC-Fax driver.
When the Sharp Advanced Printing Language-c
printer driver is being installed, this screen does not
appear. Go to the next step.
To Next Page
Loading...
Need help?
General
