Machine Environment, Installation, and Transportation -iii
G.Note for proper drum, developing, fusing and
transfer unit handling
When handling the OPC drum, developing, fusing units and transfer
units, observe the following items.
Drum unit
- To prevent damage to the OPC drum, avoid working on the drum
unit in high intensity light areas.
- When the OPC drum is removed from the machine, cover it with
light blocking material. (When using paper, use about 10 sheets of
paper to cover it.)
- Be careful not to attach fingerprints, oil, grease, or other foreign
material on the OPC drum surface.
Transfer unit
- Be careful not to "leave” fingerprints, oil, grease, or other foreign
material on the transfer roller, primary transfer belt and secondary
transfer roller.
Developing unit
- Be careful not to "leave” fingerprints, oil, grease, or other foreign
material on the developing unit.
Fusing unit
- Be careful not to "leave” fingerprints, oil, grease, or other foreign
material on the fusing roller.
- If the machine is not going to be used for an extended period,
release the pressure on the fusing rollers.
If these items are neglected, a trouble may be generated in the copy
and print image quality.
2.Transit and delivery
A.Implements, facility, and manpower
It is recommended to use a forklift when moving the machine.
If no forklift is available, man-power of two persons is required. The
machine is considerably heavy, and requires safety precautions for
delivery and installation.
Transit of the machine must be made in packed condition to the install-
ing place.
B.Delivery
Remove the packing materials prior to installation in the office environ-
ment.
No. Content Method
1 Implements, facil-
ity, and man power
Use a forklift. (If no forklift is available,
manpower of two persons is required.)
2 Delivery Transit must be made in packed condi-
tion.
To Next Page
Loading...
Need help?
General
