MX-C301 MX-C301/C301W(MAIN UNIT) 2 – 3
D. Fusing unit lever
1) Open the right door unit..
2) Turn the levers of the Fusing unit to add the pressure.
* Only the levers can add or release the pressure. There is no
screw for adding or releasing the pressure.
NOTE: When the machine is left for one month without using, the
Fusing heat roller could be deformed. If the machine is not
going to be used for an extended period, release the pres-
sure on the fusing rollers.
E.Tray size setup
1) Gently pull out the tray until it stops. If paper is in the tray,
remove it.
2) Adjust the guide plates A and B to the vertical size and the hori-
zontal size of paper.
The guide plates A and B are movable. Hold the fixing knob to
slide the guide plates A and B to match the paper size.
3) Insert the tray slowly.
4) Touch the [Paper Select] key. Then, select the tray that the
customer wants to use by touching the key of the desired tray.
F.Line cable connection (Only for the machine
with FAX)
1) Connect the telephone line to the modular jack indicated as
“LINE.”
It is necessary to prepare the line cable by yourself. The telephone
cable does not come with the machine.
When connecting the line cable (to LINE or TEL), wind the line
cable two turns around the included ferrite core as shown in the fig-
ure, and connect to the modular jack which is marked with “LINE.”
(1)
(2)
(2)
(2)
To Next Page
Loading...
Need help?
General
