Sharp MX-C507P - Page 186

5028
Diagnostics and troubleshooting
152
Action
Yes
No
Step 4
Replace the paper or change the paper size setting in the tray.
Does the problem remain?
Go to step 5.
The problem is
solved.
Step 5
Check the paper tray for overfilling.
Is the paper tray overfilled?
Go to step 6.
Go to step 7.
Step 6
Remove the excess paper from the tray.
Does the problem remain?
Go to step 7.
The problem is
solved.
Step 7
Check the paper condition in the tray.
Is the paper crumpled or damaged?
Go to step 8.
Go to step 9.
Step 8
Replace the crumpled or damaged paper.
Does the problem remain?
Go to step 9.
The problem is
solved.
Step 9
a Enter the Diagnostics menu, and then navigate to:
Additional input tray diagnostics > Sensor tests
b Find the sensor (Trailing edge (tray [x])).
Does the sensor status change while toggling the sensor?
Go to step 12.
Go to step 10.
Step 10
Reseat the sensor cable, and then check the sensor for
misalignment and damage.
Is the sensor properly installed and free of damage?
Go to step 12.
Go to step 11.
Step 11
Reinstall or replace the sensor. See “Sensor (550-sheet tray
trailing edge) removal” on page 420 .
Does the problem remain?
Go to step 12.
The problem is
solved.
Step 12
a Enter the Diagnostics menu, and then navigate to:
Additional input tray diagnostics > Sensor tests
b Find the sensor (Pass-through (tray [x])).
Does the sensor status change while toggling the sensor?
Go to step 15.
Go to step 13.