Sharp MX-C507P - Page 218

5028
Flash memory failure service check
Diagnostics and troubleshooting
184
Action
Yes
No
Step 1
Navigate to Settings > Print settings > Job Accounting Menu
Settings > Log Near Full Level . Make sure that the value is set to
maximum.
Does the problem remain?
Go to step 2.
The problem is
solved.
Step 2
If applicable, make sure that the optional memory card is
supported.
Does the problem remain?
Go to step 3.
The problem is
solved.
Step 3
Check the controller board pins for damage, and replace if
necessary. See “Controller board removal” on page 393 .
Does the problem remain?
Go to step 4.
The problem is
solved.
Step 4
Make sure that the firmware version is the latest, and update if
necessary.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Action
Yes
No
Step 10
Replace the RFID Option.
• 41X1379 (low voltage, North America)
• 41X1613 (high voltage, EMEA)
Does the problem remain?
Contact the next
level of support.
The problem is
solved.