Sharp MX-C507P - Page 254

5028
161-164 errors
161 error messages
Diagnostics and troubleshooting
220
Error code
Description
Action
161.80
The motor (tray 1 pick) did not turn on.
See “Motor (tray 1 pick) lifting error service
check” on page 222 .
161.81
The motor (tray 1 pick) did not turn off.
161.82
The motor (tray 1 pick) speed did not ramp up to
the required level.
161.83
The motor (tray 1 pick) stalled.
161.84
The motor (tray 1 pick) ran too slow.
161.85
The motor (tray 1 pick) ran too fast.
161.86
The motor (tray 1 pick) did not run at the correct
timing.
Action
Yes
No
Step 6
Reconnect the cable.
Does the problem remain?
Go to step 7.
The problem is
solved.
Step 7
Check the cable for damage, and replace if necessary.
Does the problem remain?
Go to step 8.
The problem is
solved.
Step 8
Replace the controller board. See “Controller board removal” on
page 393 .
Does the problem remain?
Contact the next
level of support.
The problem is
solved.