Sharp MX-C507P - Page 255

5028
162 error messages
163 and 164 error messages
Diagnostics and troubleshooting
221
Error code
Description
Action
163.80
The motor (tray 3 pick) did not turn on.
See “Tray pick roller assembly and lift motor
service check” on page 223 .
163.81
The motor (tray 3 pick) did not turn off.
163.82
The motor (tray 3 pick) speed did not ramp up to
the required level.
163.83
The motor (tray 3 pick) stalled.
163.84
The motor (tray 3 pick) ran too slow.
163.85
The motor (tray 3 pick) ran too fast.
163.86
The motor (tray 3 pick) did not run at the correct
timing.
164.80
The motor (tray 4 pick) did not turn on.
164.81
The motor (tray 4 pick) did not turn off.
164.82
The motor (tray 4 pick) speed did not ramp up to
the required level.
164.83
The motor (tray 4 pick) stalled.
164.84
The motor (tray 4 pick) ran too slow.
164.85
The motor (tray 4 pick) ran too fast.
164.86
The motor (tray 4 pick) did not run at the correct
timing.
Error code
Description
Action
162.80
The motor (tray 2 pick) did not turn on.
See “Tray pick roller assembly and lift motor
service check” on page 223 .
162.81
The motor (tray 2 pick) did not turn off.
162.82
The motor (tray 2 pick) speed did not ramp up to
the required level.
162.83
The motor (tray 2 pick) stalled.
162.84
The motor (tray 2 pick) ran too slow.
162.85
The motor (tray 2 pick) ran too fast.
162.86
The motor (tray 2 pick) did not run at the correct
timing.