Sharp MX-C507P - Page 259

5028
166-168 errors
166–168 error messages
Diagnostics and troubleshooting
225
166.80
The motor (tray 2 pass-through) did not turn on.
See “Motor (tray [x] transport) failure service
check” on page 226 .
166.81
The motor (tray 2 pass-through) did not turn off.
166.82
The motor (tray 2 pass-through) speed did not
ramp up to the required level.
166.83
The motor (tray 2 pass-through) stalled.
166.84
The motor (tray 2 pass-through) ran too slow.
166.85
The motor (tray 2 pass-through) ran too fast.
166.86
The motor (tray 2 pass-through) did not run at the
correct timing.
167.80
The motor (tray 3 pass-through) did not turn on.
167.81
The motor (tray 3 pass-through) did not turn off.
167.82
The motor (tray 3 pass-through) speed did not
ramp up to the required level.
167.83
The motor (tray 3 pass-through) stalled.
167.84
The motor (tray 3 pass-through) ran too slow.
167.85
The motor (tray 3 pass-through) ran too fast.
167.86
The motor (tray 3 pass-through) did not run at the
correct timing.
168.80
The motor (tray 4 pass-through) did not turn on.
168.81
The motor (tray 4 pass-through) did not turn off.
168.82
The motor (tray 4 pass-through) speed did not
ramp up to the required level.
168.83
The motor (tray 4 pass-through) stalled.
168.84
The motor (tray 4 pass-through) ran too slow.
168.85
The motor (tray 4 pass-through) ran too fast.
168.86
The motor (tray 4 pass-through) did not run at the
correct timing.