MX-C507P [4] REPLACING PARTS AND SUPPLIES 4-12
3. Remove the pick roller.
4. Unpack t
he new pick roller.
5. Insert the new pick roller until it clicks into place.
6. Close t
he multipurpose feeder.
7. Connect the power cord to the electrical outlet, and then turn on the printer.
CAUTION—POTENTIAL INJURY: To avoid the risk of fire or electrical shock, connect the power cord to
an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.
Replacing the separator pad
1. Pull out the tray.
To Next Page
Loading...
