•
If the motor fails, the test failure may not indicate a failed motor. Further troubleshooting may be
required. Check the boards and cables for possible issues.
Registration adjust
This setting lets you adjust the skew, margins, or perform a Quick Test. For more information, see
“Registration
adjustment” on page 299
.
1
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments
>
Registration adjust
2
Select a setting to adjust.
Memory tests
This setting lets you test or flash the printer memory or test or format the printer hard disk.
1
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments
>
Memory tests
2
Select a setting.
Color alignment adjust
This setting allows you to adjust the color alignments and to print or reset the default settings.
1
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments
>
Color alignment adjust
2
Select a setting.
Supply reset
The setting resets the ITM counter values to zero.
1
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments
>
Supply reset
2
Select a setting, and then touch
Start
.
Add-on cards tests
This setting allows you to test the add-on cards installed on the printer.
1
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments
>
Add
‑
on cards tests
2
Select a card.
To Next Page
Loading...
