Engine setting [x]
Warning—Potential Damage:
Do not change this setting without specific instructions from the next level of
support.
This setting allows you to select a printer engine setting. Possible values are 0–255. 0 is the default.
1
Enter the Diagnostics menu, and then navigate to:
Printer Setup
>
Engine setting [x]
2
Select a setting, enter a value, and then touch
OK
.
EP setup
Warning—Potential Damage:
Do not change this setting without specific instructions from the next level of
support.
This setting allows you to adjust the EP setup of the printer.
1
Enter the Diagnostics menu, and then navigate to:
Printer Setup
>
EP setup
2
Select a setting.
Printer diagnostics and adjustments
Enter the Diagnostics menu, and then touch
Printer diagnostics & adjustments
.
From the Sensor tests section, touch
Start
.
A dialog listing the sensor tests appears.
Find, and then manually toggle the sensor.
Notes:
•
The sensor status on the screen toggles between
1
and
0
when the sensor is properly working.
•
If a sensor test fails, the test failure may not indicate a failed sensor. Further troubleshooting may be
required. Check the boards and cables for possible issues.
Motor tests
1
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments
>
Motor tests
2
Select a motor, and then touch
Start
.
Notes:
If the motor is activated, then it is properly working.
Some motors require automatic deactivation in order to avoid secondary issues such as possible
damage and contamination.
Some tests require a special action to activate a motor such as removing a major component.
To Next Page
Loading...
