Scheduled maintenance
The control panel displays an
80.xx
error when it reaches certain page counts. It is necessary to replace the
appropriate maintenance kit to maintain print quality and printer reliability.
Note:
When replacing the maintenance kit, install all the parts that are included in the box, and then reset the
maintenance counter.
Maintenance kits
The printer may stop printing when the fuser rated life is reached. After 150K printed pages (sides) a
maintenance kit may be required. The correct fuser maintenance kit must be installed for the type of fuser that
is installed in the printer. See
“Identifying the type of fuser used in the printer” on page 450
.
The following table shows the error codes that indicate that the fuser is nearing its end of life, and that a
maintenance kit is required:
The parts are available as a maintenance kit with the following part numbers:
MXC50FK1—Fuser maintenance
kit, type 00, 110–120V
•
Fuser (110V)
•
Pick roller
•
Separator pad
Reset the fuser
maintenance
counter after
replacing the
fuser
maintenance
kit. See
“Resetting the
maintenance
counter” on
page 450
.
The maintenance kit is nearly low.
The maintenance kit is low.
The maintenance kit is very low. Only 2000 estimated pages remain.
The maintenance kit is low. 0 estimated pages remain.
The maintenance kit is very low. 0 estimated pages remain.
To Next Page
Loading...
