MX-M1204 MX-M904/M1054/M1204 (MAIN UNIT) 2 – 2
3) Poorly ventilated area
An electro-static type copier will produce ozone.
The machine is designed to produce a low quantity of ozone
so as not to affect health. Continuous use of the machine may
produce an ozone smell. Install the machine in a well venti-
lated area.
When special paper such as gloss paper is used, unique smell
or gas may be generated depending on the kind of paper,
arrange and install an additional duct to exhaust smell or gas
from the discharge section of the machine to outside of the
room. (There is no setting for the exclusive-use duct.)
4) Place of direct sunlight.
Plastic parts may become deformed, discolored, or undergo
qualitative change.
It may cause a breakdown or copy quality problems.
5) Place which is full of organic gases such as ammonium
The organic photoconductor (OPC) drum used in the machine
may undergo qualitative change due to organic gases such as
ammonium.
Installation of this machine near a diazo-type copier may result
in copy quality problems.
6) Place of excessive dust
When dusts enter the machine, it may cause a breakdown or
copy quality problems.
7) Place near a wall
The machine requires intake and exhaust of air.
If intake and exhaust of air are not properly performed, copy
quality problems or a breakdown may be result.
When installing the machine, make sure that the sides and
back of the machine are at least 11-13/16" (30 cm) away from
any walls.
11-13/16"
(30 cm)
11-13/16"
(30 cm)
11-13/16"
(30 cm)
To Next Page
Loading...
