Sharp MX-M283 - Page 682

7-34
SYSTEM SETTINGS
Contents
* When a saddle stitch finisher is installed.
Network Settings
X Disabling of Bypass-Tray in Duplex Copy Disabled 7-71
X Disabling of Auto Paper Selection Disabled 7-71
X Auto Selection Setting of Tray that is Supplied the Paper Disabled 7-71
X 600dpi x 600dpi Scanning Mode for Document Feeder Disabled 7-71
X Quick Scan from Document Glass Enabled 7-71
Item Factory default setting Page
■ Network Settings
7-72
● IPv4 Settings DHCP 7-72
● IPv6 Settings Disabled 7-72
● Enable TCP/IP Enabled 7-72
● Enable NetWare Enabled 7-72
● Enable EtherTalk Enabled 7-72
● Enable NetBEUI Enabled 7-72
● Reset the NIC – 7-72
● Ping Command – 7-72
Item Factory default setting Page