Sharp MX-M354N - Fusing Section; Toner Sensor; Thermostat; Thermistor

MX-M264U DISASSEMBLY AND ASSEMBLY 10 – 5
E. Toner sensor
• Clean the sensor only after removing used DV when replacing
DV.
• Without removing the MG roller, clean the sensor surface with
waste cloth in the arrow direction to remove toner.
3. Fusing section
A. Thermostat
CAUTION: When securing the lamp harness and the thermostat,
the tightening torque of the screw (4 positions) is 6-9
kgs.
B. Thermistor
C. Paper guide
1
2
3
1
1
1
2