1-4
BEFORE USING THE MACHINE
INTERIOR
(14) Toner cartridges
This holds toner for printing. The toner cartridge must be
replaced when indicated on the operation panel.
+
REPLACING THE TONER CARTRIDGES (page 1-55)
(15) Upper right side cover
If a paper misfeed occurs while outputting to the job
separator or the finisher (sold separately), open this
cover to remove the misfed paper.
(16) Handle
Pull this out and grasp it when moving the machine.
(17) Fusing unit
Heat is applied here to fuse the transferred image onto
the paper.
(18) Paper tray right side cover
Open this to remove a paper misfeed in tray 2 to 4.
(19) Right side cover release lever
To remove a paper misfeed, pull and hold this lever up to
open the right side cover.
(20) Bypass tray
Use this tray to feed paper manually.
When loading a large sheet of paper, be sure to pull out
the bypass tray extension.
+
LOADING PAPER IN THE BYPASS TRAY (page 1-36)
(21) Right side cover
Open this cover to remove a misfeed.
(22) Photoconductive drum
This drum has a photoconductive coating on its surface.
The images are formed on top of this photoconductive
surface. (The photoconductive coating is green in color.)
(14)
(17)
(21)(19) (20)(18) (22)
(15) (16)
Caution
The fusing unit is hot. Take care not to burn yourself
when removing a paper misfeed.
Do not touch it or damage it.
If this is not observed, image faults will occur.
To Next Page
Loading...
