Sharp MX-M3570 User Manual

12
BEFORE USING THE MACHINE
TURNING ON/OFF THE POWER
This section describes how to turn on/off the machine's power and how to restart the machine.
Operate two power switches: the main power switch inside the front cover, located in the lower left corner, and the
[Power] button on the operation panel.
Turning on the power
• Turn the main power switch to the " " position.
• When the main power indicator lights in green, press
the [Power] button.
Turning off the power
• Press the [Power] button to turn off the power.
To turn off the power for an extended time, press the [Power]
button to turn off the power, and switch the main power switch to
the " " position after the operation panel screen disappears.
Restart the machine
• Turn off the power by pressing the [Power] button and
then press it again to turn on the power.
MOTION SENSOR
(MX-M3070/M3570/M4070/M5070/M6070 only)
This sensor detects the presence of a person that approaches the machine, and automatically wakes the machine from
sleep mode (Motion Sensor Mode Only).
Three settings are available for the detection range ( / / ).
Main power
indicator
[Power]
button
Main power switch
• When turning off the main power switch, press the [Power] button on the operation panel and then turn the main power
switch to the " " position.
In a sudden case of main power outage, turn the power for the machine back on and then turn it off in the correct order.
If the machine is left for a long time with the main power having been turned off prior to the [Power] button being turned off,
abnormal noises, degraded image quality or other problems may result.
• Turn off both the [Power] button and the main power switch and unplug the power cord if you suspect a machine failure, if
there is a bad thunderstorm nearby, or when you are moving the machine.
• When using the fax or Internet fax function, always keep the main power switch in the " " position.
• In order for some settings to take effect, the machine must be restarted. In some states of the machine, restarting with the
[Power] button may not make the settings take effect. In this case, turn off the main power switch and then turn it on again.
• The motion sensor detects the movement of sources of heat.
• The detection range may vary depending on the installation site and environment (ambient temperature, etc.).
Motion sensor
Near
Far
Detection range
Approx.
maximum
1.5 m
60 degrees

Sharp MX-M3570 Specifications

General

Brand	Sharp
Model	MX-M3570
Category	All in One Printer
Language	English