2-54
COPIER
Contents
4
Insert the next set of originals and press the [START] key.
Repeat this step until all originals have been scanned.
The copy settings (Exposure, Paper Select, and Copy Ratio only) can be changed for each set of originals. If you need
to change the copy setting, follow the steps in "Changing the copy settings for each set of originals".
To cancel scanning...
Press the [STOP] key ( ). All scanned data will be cleared.
5
Touch the [Read-End] key.
To cancel copying...
Press the [STOP] key ( ).
If the Quick File Folder of document filing mode is full, copying in job build mode will be impeded. Delete unneeded files from
the Quick File Folder.
To cancel job build mode....
Touch the [Job Build] key in the screen of step 2 so that it is not highlighted.
Read-EndChange
Place next original and press [Start].
to change copy settings,
press [Change].
To Next Page
Loading...
Need help?
General
