Is there a
resistance in the
section B?
Yes
No
Increase the
clearance in
the section F
until there is a
resistance in
the section B.
However, the
max. is 5.0mm.
c) Adjust the section F.
*
If not, loosen the fixing nut and turn the section E to adjust.
Use a clearance gauge to check to confirm that the clearance
in the section F is 4.3mm - 5.0mm.
Turn section E clockwise to lift the RSPF unit. Turn it
counterclockwise to move down the RSPF unit.
*
Insert a clearance gauge in the range of 20mm from the
edge (a) of the OC mat.
Adjust the
section F.
E
20mm
a
Section F
4.3 - 5.0mm
To Next Page
Loading...
