Sharp MX-M365N - Page 307

Operation
Place the original and tap the [Preview] key.
Place the original in the document feeder tray of the automatic document feeder,
or on the document glass.
When using the document glass to scan multiple original pages, change the original
network administrator. If the master machine and slave machine will switch roles,
configure the IP address of the master machine in the slave machine. The same
port number can be used for both machines.
In this situation:
A saddle finisher is installed in the master machine while not installed in a slave
machine.
Tandem Copy is enabled when specifying copies without stapling.
Tandem Copy is disabled when specifying copies with stapling.
As shown here, if Tandem Copy is enabled using a function provided in the master
machine and not provided in a slave machine, a message will appear.
If a machine runs out of paper
If either the master machine or the slave machine run out of paper, the machine
that ran out of paper will hold the job while the machine that still has paper
continues the job. When paper is added to the machine that ran out, the job
resumes.
If user authentication is specified
Tandem Copy is enabled when user authentication is specified in the
master machine.
Tandem Copy is disabled when user authentication is specified in the
slave machine while it is not specified in the master machine.
If an odd number of sets is being made, one more set is output to the master
machine.
To use Tandem Copy:
In "Setting mode", select [System Settings] → [Device Control] → [Tandem Connection
Setting].
USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ... http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
307 of 1441 3/17/2016 7:14 AM